|
Richard
You claim to speak English, but when are you going ... En el foro Others (Archive) |
hace 9 years |
|
Or is there a alternative to ABS, for temperature resistance... En el foro Others (Archive) |
hace 9 years |
|
OK, for me, I hate to see the LED constantly flickering out ... En el foro Others (Archive) |
hace 9 years |
|
Stefano
How are you controlling the printer (Pronterface/Cu... En el foro Prusa i3 kit (Archive) |
hace 9 years |
|
Bob
Use the same pin as for the current thermistor.
Amend... En el foro Software (Archive) |
hace 9 years |
|
Bob
There is very little on this, other than what has alrea... En el foro Software (Archive) |
hace 9 years |
|
A few printers have been delivered with the bed power wired ... En el foro Others (Archive) |
hace 9 years |
|
Thanks. I went ahead and ordered a 10mil sheet.
I presume ... En el foro Others (Archive) |
hace 9 years |
|
FWIW, here's a quote from Dan @ E3D:
Both the 25w and 30w h... En el foro Others (Archive) |
hace 9 years |
|
My printer is now showing 236 metres and a print time of 21 ... En el foro Prusa i3 kit (Archive) |
hace 9 years |
|
Bill
Contact support - use the "Live Chat" on the shop page... En el foro Software (Archive) |
hace 9 years |
|
Dennis
It loos a tad over-extruded, but to be sure, can you... En el foro Others (Archive) |
hace 9 years |
|
Have you had a look at the help guide for thei:
Peter En el foro Others (Archive) |
hace 9 years |
|
I do rather think you are asking too much from the printer p... En el foro Print tips (Archive) |
hace 9 years |
|
The thermistor connector - there may not be one depending on... En el foro Prusa i3 kit (Archive) |
hace 9 years |
|
Yeah, sorry - I make changes for the Mk1 and the latest firm... En el foro Software (Archive) |
hace 9 years |
|
Try printing the pre-sliced Prusa logo file on the SD card.
... En el foro Prusa i3 kit (Archive) |
hace 9 years |
|
Daniel
I really would suggest building the printer as stock... En el foro Prusa i3 kit (Archive) |
hace 9 years |
|
Jarred
I think the most recent Mk1 firmware is 2.2.3, but I... En el foro Software (Archive) |
hace 9 years |
|
Absolutely. The printer is simply following instructions an... En el foro Print tips (Archive) |
hace 9 years |
