PJR – Activité – Prusa3D Forum

Notifications

Clear all

PJR

Groupe: Modérateur

A(ont) rejoint: 2015/06/01

Titre: Antient Member Moderator

	Marc Blue wires are for the thermistor; these were broken w... Dans le forum Others (Archive)	il y a 9 years
	Depending on the model, you can print the perimeter first (b... Dans le forum Others (Archive)	il y a 9 years
	Or filament tension too tight. Peter Dans le forum Others (Archive)	il y a 9 years
	Berndt This is what I would do: Put everything back to sto... Dans le forum General discussion, announcements and releases	il y a 9 years
	Ah. Just seen the one. I believe it's this filament: I u... Dans le forum Others (Archive)	il y a 9 years
	Checkout this: Peter Dans le forum Others (Archive)	il y a 9 years
	Jeff. Pleasure. I really still don't like the Github organi... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Soak the bearings in IPA. The screws at the right side of t... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Yes. From experience I found that the lower the live Z adju... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Matthias Yes, it is getting a tad close when you get the no... Dans le forum Print tips (Archive)	il y a 9 years
	Ideally, the anti-rusting oil coating applied on the bearing... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	i didn't have any success too (i don't get a linear change o... Dans le forum General discussion, announcements and releases	il y a 9 years
	Sounds as though the filament pulley is grinding the filamen... Dans le forum Others (Archive)	il y a 9 years
	If it's the painted griffin model you are looking at, they R... Dans le forum Others (Archive)	il y a 9 years
	Nico There are times when you just have to say that it's go... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	If you are printing from SD card, then you maybe didn't allo... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Jeff Here is 3.0.8 with the relevant Configuration.prusa.h.... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	David Whichever way you feel is best for you, but at least ... Dans le forum Improvements (Archive)	il y a 9 years
	You need rear -50 and front +50... Peter Dans le forum Others (Archive)	il y a 9 years
	Yes, under A and C and push B and D The point here is to ge... Dans le forum Others (Archive)	il y a 9 years

Page 138 / 281 Précédent Suivant

Statistiques du forum

585 Forums

68.5 K Sujets

479.3 K Messages

9 En-ligne

76.6 K Membres

Le dernier des messages: Software Recommendations Needed Notre nouveau membre: Camster Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé