|
is there an easy way to check the accuracy of the extruder t... In forum Others (Archive) |
8 years ago |
|
Rather than use relays, you may consider using a darlington ... In forum Improvements (Archive) |
8 years ago |
|
I tryed everything to get it to print. All it does is jam. i... In forum Others (Archive) |
8 years ago |
|
There are a few temperatures you need to consider and they w... In forum Others (Archive) |
8 years ago |
|
Why not do the levelling before heating up things?
The bed ... In forum Others (Archive) |
8 years ago |
|
What's the reasoning behind that? If I read correctly, you a... In forum Others (Archive) |
8 years ago |
|
Well, I don't re-calibrate XYZ after a firmware update, so I... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Yes, they are the points a to h (note: lower case).
This on... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Yeah, you don't need to print it with a skirt!
OK, so if th... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Slice and print the attached and upload a photo of the print... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Intermittent extrusion, porous prints.
Yeah, you are having... In forum Others (Archive) |
8 years ago |
|
There are a couple of commands you need to issue when doing ... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Corey
I think you need to go back and look at the photos yo... In forum Others (Archive) |
8 years ago |
|
This is a rather interesting query, although not one I have ... In forum Improvements (Archive) |
8 years ago |
|
Use the bed level correction and take the left side down by ... In forum Others (Archive) |
8 years ago |
|
hehe... you've got the single strain at adalinda's belly as ... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Use the bed level correction and take the left side down by ... In forum Others (Archive) |
8 years ago |
|
Yes, I am aware of corporate discounts. So basically buying... In forum Others (Archive) |
8 years ago |
|
Pleasure to assist.
Interestingly, this is what I am curren... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Paul
For each extruder the following sequence occurs:
Move... In forum Others (Archive) |
8 years ago |
