Notifications
Clear all
PhillTheIntern
Group: Registered
Joined: 2021/09/01
Active Member
1
|
Thats very good to know! Much appreciated. In forum PrusaSlicer |
3 years ago | |
|
Thanks to you both! That was the solution to this problem. I... In forum PrusaSlicer |
3 years ago | |
|
Help Needed with Slicing Issue In forum PrusaSlicer |
3 years ago | |
|
I just did, I did not realize it was needed when I initially... In forum Hardware, firmware and software help |
3 years ago | |
|
Well, I am glad you had me take a picture of the nozzle, bec... In forum Hardware, firmware and software help |
3 years ago | |
|
Yes, The first layer calibration has been done and the begin... In forum Hardware, firmware and software help |
3 years ago | |
|
Printer extruding large strands that mess up final prints. In forum Hardware, firmware and software help |
3 years ago |