Prusa3D Forum

Notifications

Clear all

philippe.c

Skupina: Registrovaný

Přidal se: 2015/09/22

Active Member

	Hello .. by going up I mean the head bed screws were going s... In forum Prusa i3 kit (Archive)	před 9 years
	Too stupid from me 😉 .. Thanks a lot I tough I was missi... In forum Prusa i3 kit (Archive)	před 9 years
	Hello, Here is a video or start printing .. it does not see... In forum Prusa i3 kit (Archive)	před 9 years
	Ok I found a workaround .. I export settings from slic3r 1.7... In forum Prusa i3 kit (Archive)	před 9 years
	Slice3r 1.75 crashing at Gcode export In forum Prusa i3 kit (Archive)	před 9 years
	Yes I also noticed last time change of temperature just befo... In forum Prusa i3 kit (Archive)	před 9 years
	I makes some shocks on the end of axis .. just like the beld... In forum Prusa i3 kit (Archive)	před 9 years
	Thank you .. I was using slice3r but change parameters for f... In forum Prusa i3 kit (Archive)	před 9 years
	I uploaded latest firmware Marlin1-0-3_RamboMini1-3_EN Now ... In forum Prusa i3 kit (Archive)	před 9 years
	[SOLVED] Strange behaviour at start - Auto home hiting sides... In forum Prusa i3 kit (Archive)	před 9 years
	[SOLVED] Err: MAXTEMP In forum Prusa i3 kit (Archive)	před 9 years

Fórum Statistiky

565 Fóra

63.6 K Témata

446.2 K Příspěvky

20 Online

68.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed