Prusa3D Forum

Notifications

Clear all

philippe.c2

Grupa: Zarejestrowany

Dołączył: 2015/09/29

Active Member

	Hello, Just a small feedback ..I managed to unclog it with... In forum Prusa i3 kit (Archive)	9 years temu
	Hello, Just a small feedback ..I managed to unclog it with... In forum Prusa i3 kit (Archive)	9 years temu
	Hello, I have the same issue (see two post below) .. Nozzle ... In forum Prusa i3 kit (Archive)	9 years temu
	My sd card reader is not working all the time neither .. I ... In forum Prusa i3 kit (Archive)	9 years temu
	Extruder nozzle stoppered / clogged In forum Prusa i3 kit (Archive)	9 years temu
	I had the same issue and ended by fixing the bed to the carr... In forum Prusa i3 kit (Archive)	9 years temu
	Small rings 5 mm radius 2 mm thikness In forum Awesome prints (Hall Of Fame)	9 years temu
	First print ABS and PLA In forum Awesome prints (Hall Of Fame)	9 years temu
	Default temp 50*C .. it tried hotter (60°C) but it was not b... In forum Prusa i3 kit (Archive)	9 years temu
	Howto ABS & PLA stick to heat bed In forum Prusa i3 kit (Archive)	9 years temu
	Congratulations and thanks ! In forum Prusa i3 kit (Archive)	9 years temu
	Fixing the Heat Bed In forum Prusa i3 kit (Archive)	9 years temu
	That was the problem .. using Slice3r and setting 1.75 filam... In forum Prusa i3 kit (Archive)	9 years temu
	Ok I got it, the bar must be pushed quite deep inside the pl... In forum Prusa i3 kit (Archive)	9 years temu
	Stuck at step 16 Axis Z .. In forum Prusa i3 kit (Archive)	9 years temu

Statystyki Forum

565 Fora

63.6 K Tematy

446.2 K Posty

21 Online

68.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte