|
Hello,
Just a small feedback ..I managed to unclog it with... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Hello,
Just a small feedback ..I managed to unclog it with... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Hello,
I have the same issue (see two post below) ..
Nozzle ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
My sd card reader is not working all the time neither ..
I ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Extruder nozzle stoppered / clogged In forum Prusa i3 kit (Archive) |
9 years ago |
|
I had the same issue and ended by fixing the bed to the carr... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Small rings 5 mm radius 2 mm thikness In forum Awesome prints (Hall Of Fame) |
9 years ago |
|
First print ABS and PLA In forum Awesome prints (Hall Of Fame) |
9 years ago |
|
Default temp 50*C .. it tried hotter (60°C) but it was not b... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Howto ABS & PLA stick to heat bed In forum Prusa i3 kit (Archive) |
9 years ago |
|
Congratulations and thanks ! In forum Prusa i3 kit (Archive) |
9 years ago |
|
Fixing the Heat Bed In forum Prusa i3 kit (Archive) |
9 years ago |
|
That was the problem .. using Slice3r and setting 1.75 filam... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Ok I got it, the bar must be pushed quite deep inside the pl... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Stuck at step 16 Axis Z .. In forum Prusa i3 kit (Archive) |
9 years ago |
