Prusa3D Forum

Notifiche

Cancella tutti

Pez

Gruppo: Registrato

Registrato: 2021/01/17

Active Member

	I've figured it out. Sadly, the problem is in the motor. I'l... Nel forum Hardware, firmware and software help	5 years fa
	OK, latest update: it seems the bearing will turn, though it... Nel forum Hardware, firmware and software help	5 years fa
	i have loosened off the x-axis end cap and am able to slip t... Nel forum Hardware, firmware and software help	5 years fa
	No, I cannot move it by hand, even when turned off. It moves... Nel forum Hardware, firmware and software help	5 years fa
	@j-boshoven Thank you. Would that be at the small end of t... Nel forum Hardware, firmware and software help	5 years fa
	RE: X axis jammed after spaghetti Nel forum Hardware, firmware and software help	5 years fa
	X axis jammed after spaghetti Nel forum Hardware, firmware and software help	5 years fa

Statistiche Forum

585 Forum

68.2 K Discussioni

477.5 K Post

11 Online

75.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso