|
You probably should have ordered an MK2S then. En el foro General discussion, announcements and releases |
hace 7 years |
|
I think it is because of the e3d hotend. It needs much less ... En el foro Others (Archive) |
hace 7 years |
|
whos the lucky devil that ordered in december and got a ship... En el foro General discussion, announcements and releases |
hace 7 years |
|
Brand recognition. En el foro General discussion, announcements and releases |
hace 7 years |
|
It is decided by the row
#define EXTRUDE_MINTEMP 190
in Conf... En el foro Others (Archive) |
hace 7 years |
|
What else are we supposed to say? "Try looking under the cou... En el foro Others (Archive) |
hace 7 years |
|
you probably could have used Tom's hand as a reference so th... En el foro Others (Archive) |
hace 7 years |
|
I was a bit puzzled about what you used as a basis for your ... En el foro Others (Archive) |
hace 7 years |
|
Thanks for the input. I am off to get it.
How close was my... En el foro Others (Archive) |
hace 7 years |
|
Using screenshots from Tom's unboxing and build video, my gu... En el foro Others (Archive) |
hace 7 years |
|
I think curtis.c2 means these screws.
Did you miss one im... En el foro Others (Archive) |
hace 7 years |
|
If they arent on the Z-axis motor leadscrews, contact suppor... En el foro Others (Archive) |
hace 7 years |
|
Just a G4 without parameters shouldn't do anything, right? P... En el foro Others (Archive) |
hace 7 years |
|
Yeah, I did that this morning.
Hotrian sent me a PM and I d... En el foro General discussion, announcements and releases |
hace 7 years |
|
Can we change the ranges for the highlighting etc. from G2:G... En el foro General discussion, announcements and releases |
hace 7 years |
|
And the fan isn't spinning backwards? En el foro Others (Archive) |
hace 7 years |
|
Unfortunately I can't push the highlighting forward on the O... En el foro General discussion, announcements and releases |
hace 7 years |
|
Can we say confirmed now? Ordered 10/28 and finally received... En el foro General discussion, announcements and releases |
hace 7 years |
|
@ Zaz
Yes i try this too and I get the message invalid numbe... En el foro General discussion, announcements and releases |
hace 7 years |
|
I thought it was hardened vs not hardened, not stainless vs ... En el foro Hardware, firmware and software help |
hace 7 years |
