pcweber – Activité – Prusa3D Forum

Notifications

Clear all

pcweber

Groupe: PrusaLink-beta

A(ont) rejoint: 2019/12/16

Titre: Membre

	As one can see in the image the first layer is practically p... Dans le forum Print tips (Archive)	il y a 6 years
	RE: MK3S with Sunlu new PLA+ filament Dans le forum Print tips (Archive)	il y a 6 years
	Great, I'll order the spares and include some socks, since I... Dans le forum Hardware, firmware and software help	il y a 6 years
	@chocki Thank you for bringing this up, I continued to have ... Dans le forum Hardware, firmware and software help	il y a 6 years
	@bobstro Doesn't the silicon sock come off at times? On my ... Dans le forum Hardware, firmware and software help	il y a 6 years
	Hi, I did indeed heat and twist at 280, outside of the extru... Dans le forum Hardware, firmware and software help	il y a 6 years
	@chocki I just ran into this situation and did, in fact, bre... Dans le forum Hardware, firmware and software help	il y a 6 years
	Thank you for this post and the solution to a problem that I... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	@michele-b3 Thanks, Once I get my new machine, after buildi... Dans le forum Print tips (Archive)	il y a 6 years
	Hi, Although I am still awaiting the arrival of my first Mk3... Dans le forum Print tips (Archive)	il y a 6 years

Page 10 / 10 Précédent

Statistiques du forum

585 Forums

68 K Sujets

476.8 K Messages

11 En-ligne

75.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé