Čeština
Fóra
Uživatelé
Pavel
Aktivita
 
Notifications
Clear all
Pavel
Pavel
Skupina: Registrovaný
Přidal se: 2019/04/20
Eminent Member
2
Profile Aktivita
I stand corrected. With the "Don't support bridges" not chec...

In forum How do I print this? (Printing help)

 před 4 years
@neophyl thanks I did find the setting for 'Don't support br...

In forum How do I print this? (Printing help)

 před 4 years
printing cavity - support is not working as it should IMHO

In forum How do I print this? (Printing help)

 před 4 years
@neophyl you are correct, the search is not the best. Before...

In forum How do I print this? (Printing help)

 před 4 years
Better, but not perfect. Simplify3D still better. I must be ...

In forum How do I print this? (Printing help)

 před 4 years
@neophyl I don't know how I missed that. I am printing at 18...

In forum How do I print this? (Printing help)

 před 4 years
while it is printing and 180deg.: note the different support...

In forum How do I print this? (Printing help)

 před 4 years
@neophyl thanks - I'll try 180deg. In slicer it does look ...

In forum How do I print this? (Printing help)

 před 4 years
@neophyl I tried - the angle in the example is set to zero(0...

In forum How do I print this? (Printing help)

 před 4 years
Both parts were printed with support - I left some of the su...

In forum How do I print this? (Printing help)

 před 4 years
Bridging and support

In forum How do I print this? (Printing help)

 před 4 years
Firmware update issue - USB install

In forum Hardware, firmware and software help

 před 5 years
All good suggestions: with_maltodextrin -- I did step 1 .....

In forum Hardware, firmware and software help

 před 5 years
I'll upload the .3mF later today. I am trying to figure out...

In forum How do I print this? (Printing help)

 před 5 years
On my old printer I had an access to the eeprom, and I could...

In forum Hardware, firmware and software help

 před 5 years
unfortunately: no I can't. The top has even more complicat...

In forum How do I print this? (Printing help)

 před 5 years
Steps per millimeter correction

In forum Hardware, firmware and software help

 před 5 years
bobstro did not finish the advice ... ;>) but even more ...

In forum How do I print this? (Printing help)

 před 5 years
I like this one (Avery Glue Stic #00226) works well for me ...

In forum Print tips (Archive)

 před 5 years
bridging instead of support issue

In forum How do I print this? (Printing help)

 před 5 years
Stránka 1 / 2
Share: