Prusa3D Forum

Notifications

Clear all

Paulgs

Groupe: Enregistré

A(ont) rejoint: 2021/06/01

Active Member

	Adding MMU2 to MK3S+ problems Dans le forum General discussion, announcements and releases	il y a 3 years
	Not sure what the post is all about. If this is a Technical ... Dans le forum General discussion, announcements and releases	il y a 3 years
	Printer has no input Dans le forum General discussion, announcements and releases	il y a 3 years
	Painters tape Dans le forum General discussion, announcements and releases	il y a 4 years
	OK, I have things working, except to get the filament to sti... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@bobstro Yes Live Z. I think I am getting close to things go... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	I opened up the extruder door and there was some melted fila... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@cwbullet Just to let you know: Everything but the heat bed ... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Everything is going wrong Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Is the position still open? I am a retired Technical Writer.... Dans le forum General discussion, announcements and releases	il y a 4 years
	@aaron-s5 Thanks, this should be in the book. Dans le forum Assembly and first prints troubleshooting	il y a 4 years

Statistiques du forum

565 Forums

64.1 K Sujets

449.1 K Messages

24 En-ligne

70.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé