Notifications
Clear all
Paul Meyer
Paul Meyer
Skupina: Registrovaný
Přidal se: 2017/09/23
Honorable Member
1
Are those files for the slim 350w mean well PSU or the regul...

In forum Hardware, firmware and software help

před 7 years
Thanks. I hope you mean the NES-350-24 and not the 12. The...

In forum Hardware, firmware and software help

před 7 years
Are those files for the slim 350w mean well PSU or the regul...

In forum Hardware, firmware and software help

před 7 years
Here's a question for you all. If you move your print head m...

In forum Hardware, firmware and software help

před 7 years
Nice design, but my two cents... I would refrain from fasten...

In forum Hardware, firmware and software help

před 7 years
Here's a question for you all. If you move your print head m...

In forum Hardware, firmware and software help

před 7 years
Mode 2 sounds about right. Pretty frustrating experience rig...

In forum Hardware, firmware and software help

před 7 years
I picked up the mean well and got it installed. Everything i...

In forum Hardware, firmware and software help

před 7 years
Power supply failure here as well. Printed great the first d...

In forum Hardware, firmware and software help

před 7 years
So I decided to put a watt meter on the printer to see its p...

In forum Hardware, firmware and software help

před 7 years
To the original question: I generally use simplify3d for sl...

In forum Others (Archive)

před 7 years
For those that had a power supply go bad, were any of them c...

In forum Hardware, firmware and software help

před 7 years
prusa ships 2nd day air for replacement parts, for me they w...

In forum Hardware, firmware and software help

před 7 years
Can you clarify what you are doing? Have you run the xyz ca...

In forum Others (Archive)

před 7 years
So my PSU just failed. Nothing as dramatic, but about 30 min...

In forum Hardware, firmware and software help

před 7 years
I am having problems with my mk3 filament sensor, the mk3 mm...

In forum Others (Archive)

před 7 years
I need less live-z adjust (-0.35 for PLA, -0.15 or so for PE...

In forum Others (Archive)

před 7 years
I am printing successfully with PETG. I have a bit of rando...

In forum Others (Archive)

před 7 years
If the room lights are flashing in sync to the clicking, I w...

In forum Hardware, firmware and software help

před 7 years
Im glad there are cheap PSU alternatives available. Full d...

In forum Hardware, firmware and software help

před 7 years
Stránka 16 / 27
Share: