Prusa3D Forum

Notifications

Clear all

paul.f3

Skupina: Registrovaný

Přidal se: 2017/02/19

Active Member

	Just thought I would follow up to share how I resolved the i... In forum Assembly and first prints troubleshooting	před 6 years
	I haven't. Thanks for the suggestion, I'll give that a try. In forum Assembly and first prints troubleshooting	před 6 years
	Yeah I spotted the firmware release, so like you say, though... In forum Assembly and first prints troubleshooting	před 6 years
	Hmm, okay I'll try again and just do z calibration with the ... In forum Assembly and first prints troubleshooting	před 6 years
	Hi there, yep the light on the sensor lights - it goes on &a... In forum Assembly and first prints troubleshooting	před 6 years
	Any ideas at all? Do Prusa monitor this board? In forum Assembly and first prints troubleshooting	před 6 years
	Z axis calibration fails after Mk2.5S upgrade In forum Assembly and first prints troubleshooting	před 6 years

Fórum Statistiky

565 Fóra

64.1 K Témata

449.2 K Příspěvky

20 Online

70.2 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed