Notifications
Clear all
Paul beard
Group: Registered
Joined: 2023/09/01
Trusted Member
3
|
What makes a Prusa lose its z-height calibration? In forum Hardware, firmware and software help |
2 years ago | |
|
I'll wait. 3.11 seems fine. In forum Hardware, firmware and software help |
3 years ago | |
|
That is what I had assumed. Thank you. In forum Others (Archive) |
3 years ago | |
|
So it's Ok if the LED flickers during a job? I am seeing som... In forum Others (Archive) |
3 years ago | |
|
Yikes, I just updated the firmware on one of these in hopes ... In forum Hardware, firmware and software help |
3 years ago |
Page 5 / 5
Prev