Notifications
Clear all
patrick.g16
Groupe: Enregistré
A(ont) rejoint: 2018/05/05
Active Member
1
|
@bobstro I did that and reverted back to 3.8.1 and was able ... Dans le forum Hardware, firmware and software help |
il y a 4 years | |
|
So I was able to go into Printer Settings (Advanced) and mod... Dans le forum Hardware, firmware and software help |
il y a 4 years | |
|
Modified my GCode to remove the M115 line and reverted back ... Dans le forum General discussion, announcements and releases |
il y a 4 years | |
|
So my printer is actually not working as it's saying to flas... Dans le forum Hardware, firmware and software help |
il y a 4 years | |
|
I upgraded my firmware to 3.9.0 today, and now my printer is... Dans le forum General discussion, announcements and releases |
il y a 5 years | |
|
I've reverted back to 3.8.1 for now, and my printer is worki... Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
MK3 stuck in startup loop after upgrade to 3.9.0 Dans le forum Hardware, firmware and software help |
il y a 5 years |