Notifications
Clear all
Panda
Group: Registered
Joined: 2019/08/04
Active Member
1
|
@roman-t Thank you! I completely missed that setting. In forum Hardware, firmware and software help |
4 years ago | |
|
MK3S doing Z-Hop, even its turned off in PrusaSlicer In forum Hardware, firmware and software help |
4 years ago | |
|
Wow, this looks realy nice. In forum Awesome prints (Hall Of Fame) |
5 years ago | |
|
I lowered the speed and enabled the bridge detection. The st... In forum How do I print this? (Printing help) |
5 years ago | |
|
Thank you for your tipps, I will try them. And also thank yo... In forum How do I print this? (Printing help) |
5 years ago | |
|
Hi Tim, thanks for your reply.I have searched PrusaSlicer2 f... In forum How do I print this? (Printing help) |
5 years ago | |
|
Whats the cause of this edge? In forum How do I print this? (Printing help) |
5 years ago | |
| Check the idler screw from the bondtech gears. As soon it ca... | 5 years ago |