Attività
 
Notifiche
Cancella tutti
paj418
paj418
Gruppo: Registrato
Registrato: 2023/01/12
Eminent Member
2
Prusa asked me to remove the fan shroud and take some pictur...

Nel forum Assembly and first prints troubleshooting

1 month fa
My Mk4 (upgraded from a Mk3) is still under warranty, so Pru...

Nel forum Assembly and first prints troubleshooting

2 months fa
Prusa support finally got back to me this morning: "Could yo...

Nel forum Assembly and first prints troubleshooting

2 months fa
Yes, I’ve been aware of that setting since I upgraded from m...

Nel forum Assembly and first prints troubleshooting

2 months fa
Thermal runaway

Nel forum Assembly and first prints troubleshooting

2 months fa
Here's a link to the file: In his print instructions, the d...

Nel forum How do I print this? (Printing help)

6 months fa
How do I correct print ordering

Nel forum How do I print this? (Printing help)

6 months fa
I had turned the printer off. After about 1/2 hour, I though...

Nel forum Hardware, firmware and software help

1 year fa
Uneven extrusion

Nel forum Hardware, firmware and software help

1 year fa
Basement temp was 64F this morning. Increased first layer te...

Nel forum How do I print this? (Printing help)

2 years fa
Great insight! Thanks. The outside temperature here has gone...

Nel forum How do I print this? (Printing help)

2 years fa
I did to clean the nozzle. For printing, I've been using the...

Nel forum How do I print this? (Printing help)

2 years fa
Need ideas on why this is happening?

Nel forum How do I print this? (Printing help)

2 years fa
Yes, it's a MK3S+. I previously ran the Configuration Wizard...

Nel forum PrusaSlicer

2 years fa
PrusaSlicer settings for 0.6 mm nozzle

Nel forum PrusaSlicer

2 years fa
Nothing in the designer notes. By fooling around with the pr...

Nel forum How do I print this? (Printing help)

2 years fa
I could use some help with the Prusa Slicer

Nel forum How do I print this? (Printing help)

2 years fa
My suggestion is to follow Joan's advice. It certainly got m...

Nel forum Assembly and first prints troubleshooting

2 years fa
I ended up at Z -1.475 and achieved success: My sincere tha...

Nel forum Assembly and first prints troubleshooting

2 years fa
Here's where I started (the second number is the print thick...

Nel forum Assembly and first prints troubleshooting

2 years fa
Pagina 1 / 2
Condividi: