Prusa3D Forum

Notifications

Clear all

paj418

Groupe: Enregistré

A(ont) rejoint: 2023/01/12

Eminent Member

	Prusa asked me to remove the fan shroud and take some pictur... Dans le forum Assembly and first prints troubleshooting	il y a 1 month
	My Mk4 (upgraded from a Mk3) is still under warranty, so Pru... Dans le forum Assembly and first prints troubleshooting	il y a 2 months
	Prusa support finally got back to me this morning: "Could yo... Dans le forum Assembly and first prints troubleshooting	il y a 2 months
	Yes, I’ve been aware of that setting since I upgraded from m... Dans le forum Assembly and first prints troubleshooting	il y a 2 months
	Thermal runaway Dans le forum Assembly and first prints troubleshooting	il y a 2 months
	Here's a link to the file: In his print instructions, the d... Dans le forum How do I print this? (Printing help)	il y a 6 months
	How do I correct print ordering Dans le forum How do I print this? (Printing help)	il y a 6 months
	I had turned the printer off. After about 1/2 hour, I though... Dans le forum Hardware, firmware and software help	il y a 1 year
	Uneven extrusion Dans le forum Hardware, firmware and software help	il y a 1 year
	Basement temp was 64F this morning. Increased first layer te... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Great insight! Thanks. The outside temperature here has gone... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I did to clean the nozzle. For printing, I've been using the... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Need ideas on why this is happening? Dans le forum How do I print this? (Printing help)	il y a 2 years
	Yes, it's a MK3S+. I previously ran the Configuration Wizard... Dans le forum PrusaSlicer	il y a 2 years
	PrusaSlicer settings for 0.6 mm nozzle Dans le forum PrusaSlicer	il y a 2 years
	Nothing in the designer notes. By fooling around with the pr... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I could use some help with the Prusa Slicer Dans le forum How do I print this? (Printing help)	il y a 2 years
	My suggestion is to follow Joan's advice. It certainly got m... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	I ended up at Z -1.475 and achieved success: My sincere tha... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Here's where I started (the second number is the print thick... Dans le forum Assembly and first prints troubleshooting	il y a 2 years

Page 1 / 2 Suivant

Statistiques du forum

565 Forums

63.6 K Sujets

446.2 K Messages

18 En-ligne

68.9 K Membres

Le dernier des messages: X und Y Kalibrierung vor jedem Druck (?) Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé