Aktivität
 
Benachrichtigungen
Alles löschen
paj418
paj418
Gruppe: Registriert
Beigetreten: 2023/01/12
Eminent Member
2
Prusa asked me to remove the fan shroud and take some pictur...

Im Forum Assembly and first prints troubleshooting

Vor 1 month
My Mk4 (upgraded from a Mk3) is still under warranty, so Pru...

Im Forum Assembly and first prints troubleshooting

Vor 2 months
Prusa support finally got back to me this morning: "Could yo...

Im Forum Assembly and first prints troubleshooting

Vor 2 months
Yes, I’ve been aware of that setting since I upgraded from m...

Im Forum Assembly and first prints troubleshooting

Vor 2 months
Thermal runaway

Im Forum Assembly and first prints troubleshooting

Vor 2 months
Here's a link to the file: In his print instructions, the d...

Im Forum How do I print this? (Printing help)

Vor 6 months
How do I correct print ordering

Im Forum How do I print this? (Printing help)

Vor 6 months
I had turned the printer off. After about 1/2 hour, I though...

Im Forum Hardware, firmware and software help

Vor 1 year
Uneven extrusion

Im Forum Hardware, firmware and software help

Vor 1 year
Basement temp was 64F this morning. Increased first layer te...

Im Forum How do I print this? (Printing help)

Vor 2 years
Great insight! Thanks. The outside temperature here has gone...

Im Forum How do I print this? (Printing help)

Vor 2 years
I did to clean the nozzle. For printing, I've been using the...

Im Forum How do I print this? (Printing help)

Vor 2 years
Need ideas on why this is happening?

Im Forum How do I print this? (Printing help)

Vor 2 years
Yes, it's a MK3S+. I previously ran the Configuration Wizard...

Im Forum PrusaSlicer

Vor 2 years
PrusaSlicer settings for 0.6 mm nozzle

Im Forum PrusaSlicer

Vor 2 years
Nothing in the designer notes. By fooling around with the pr...

Im Forum How do I print this? (Printing help)

Vor 2 years
I could use some help with the Prusa Slicer

Im Forum How do I print this? (Printing help)

Vor 2 years
My suggestion is to follow Joan's advice. It certainly got m...

Im Forum Assembly and first prints troubleshooting

Vor 2 years
I ended up at Z -1.475 and achieved success: My sincere tha...

Im Forum Assembly and first prints troubleshooting

Vor 2 years
Here's where I started (the second number is the print thick...

Im Forum Assembly and first prints troubleshooting

Vor 2 years
Seite 1 / 2
Teilen: