Prusa3D Forum

Notifications

Clear all

paj418

Skupina: Registrovaný

Přidal se: 2023/01/12

Eminent Member

	Prusa asked me to remove the fan shroud and take some pictur... In forum Assembly and first prints troubleshooting	před 1 month
	My Mk4 (upgraded from a Mk3) is still under warranty, so Pru... In forum Assembly and first prints troubleshooting	před 2 months
	Prusa support finally got back to me this morning: "Could yo... In forum Assembly and first prints troubleshooting	před 2 months
	Yes, I’ve been aware of that setting since I upgraded from m... In forum Assembly and first prints troubleshooting	před 2 months
	Thermal runaway In forum Assembly and first prints troubleshooting	před 2 months
	Here's a link to the file: In his print instructions, the d... In forum How do I print this? (Printing help)	před 6 months
	How do I correct print ordering In forum How do I print this? (Printing help)	před 6 months
	I had turned the printer off. After about 1/2 hour, I though... In forum Hardware, firmware and software help	před 1 year
	Uneven extrusion In forum Hardware, firmware and software help	před 1 year
	Basement temp was 64F this morning. Increased first layer te... In forum How do I print this? (Printing help)	před 2 years
	Great insight! Thanks. The outside temperature here has gone... In forum How do I print this? (Printing help)	před 2 years
	I did to clean the nozzle. For printing, I've been using the... In forum How do I print this? (Printing help)	před 2 years
	Need ideas on why this is happening? In forum How do I print this? (Printing help)	před 2 years
	Yes, it's a MK3S+. I previously ran the Configuration Wizard... In forum PrusaSlicer	před 2 years
	PrusaSlicer settings for 0.6 mm nozzle In forum PrusaSlicer	před 2 years
	Nothing in the designer notes. By fooling around with the pr... In forum How do I print this? (Printing help)	před 2 years
	I could use some help with the Prusa Slicer In forum How do I print this? (Printing help)	před 2 years
	My suggestion is to follow Joan's advice. It certainly got m... In forum Assembly and first prints troubleshooting	před 2 years
	I ended up at Z -1.475 and achieved success: My sincere tha... In forum Assembly and first prints troubleshooting	před 2 years
	Here's where I started (the second number is the print thick... In forum Assembly and first prints troubleshooting	před 2 years

Stránka 1 / 2 Další

Fórum Statistiky

565 Fóra

63.6 K Témata

446.2 K Příspěvky

24 Online

68.9 K Uživatelé

Poslední Příspěvek: Xl extruder stops Nový Uživatel: Kiley Murphy Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed