Prusa3D Forum

Notifications

Clear all

Otter Arms

Skupina: Registrovaný

Přidal se: 2019/07/18

Active Member

	Has anyone had a definitive solution to this? I am experienc... In forum Hardware, firmware and software help	před 3 years
	Thanks for all the info in this thread. I am having issues w... In forum Hardware, firmware and software help	před 4 years
	@baklin Thanks! That would explain it. I was printing before... In forum Hardware, firmware and software help	před 4 years
	Purging in mid air on last layer In forum Hardware, firmware and software help	před 4 years
	@tim-m30 For my PLA it is M900 K{if printer_notes=~/.*PRINTE... In forum PrusaSlicer	před 6 years
	@tim-m30 I tried getting rid of the gap closing radius and i... In forum PrusaSlicer	před 6 years
	@joantabb I am able to confirm that by watching the print. I... In forum PrusaSlicer	před 6 years
	Gaps in perimeter In forum PrusaSlicer	před 6 years
	First Layer Woes In forum Assembly and first prints troubleshooting	před 6 years
	Mine doesn't do it as much anymore but I still get it occasi... In forum Hardware, firmware and software help	před 6 years
	Yes and yes. If I manually move the idler with the door open... In forum Hardware, firmware and software help	před 6 years
	Hi Joan. The gears are lined up and the drive wheel is firml... In forum Hardware, firmware and software help	před 6 years
	Extruder Idler Rattling In forum Hardware, firmware and software help	před 6 years

Fórum Statistiky

585 Fóra

68.2 K Témata

477.5 K Příspěvky

11 Online

75.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed