Prusa3D Forum

Notifications

Clear all

Otter Arms

Grupa: Zarejestrowany

Dołączył: 2019/07/18

Active Member

	Has anyone had a definitive solution to this? I am experienc... In forum Hardware, firmware and software help	3 years temu
	Thanks for all the info in this thread. I am having issues w... In forum Hardware, firmware and software help	4 years temu
	@baklin Thanks! That would explain it. I was printing before... In forum Hardware, firmware and software help	4 years temu
	Purging in mid air on last layer In forum Hardware, firmware and software help	4 years temu
	@tim-m30 For my PLA it is M900 K{if printer_notes=~/.*PRINTE... In forum PrusaSlicer	6 years temu
	@tim-m30 I tried getting rid of the gap closing radius and i... In forum PrusaSlicer	6 years temu
	@joantabb I am able to confirm that by watching the print. I... In forum PrusaSlicer	6 years temu
	Gaps in perimeter In forum PrusaSlicer	6 years temu
	First Layer Woes In forum Assembly and first prints troubleshooting	6 years temu
	Mine doesn't do it as much anymore but I still get it occasi... In forum Hardware, firmware and software help	6 years temu
	Yes and yes. If I manually move the idler with the door open... In forum Hardware, firmware and software help	6 years temu
	Hi Joan. The gears are lined up and the drive wheel is firml... In forum Hardware, firmware and software help	6 years temu
	Extruder Idler Rattling In forum Hardware, firmware and software help	6 years temu

Statystyki Forum

585 Fora

68.2 K Tematy

477.7 K Posty

10 Online

75.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte