Activité
 
Notifications
Clear all
Othila
Othila
Groupe: Enregistré
A(ont) rejoint: 2021/06/28
Eminent Member
2
Thanks mate, I purchased a dryer as I had other issues with ...

Dans le forum How do I print this? (Printing help)

il y a 3 years
Thank you for the link and yes I have watched this previousl...

Dans le forum PrusaSlicer

il y a 3 years
Prusa Slicer v Cura Dec 2021

Dans le forum PrusaSlicer

il y a 3 years
Thanks for the advice, I'll look into a food dehydrator and ...

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
Thanks, I've also read about putting PLA into and oven on lo...

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
I was thinking that moisture was the culprit, any fixes that...

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
PLA Orange weird extrude issue, any advice?

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
Yes I always warm the machine and bed prior to every session...

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
I do look at Z height every print however this machine decid...

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
Same sheet as always, nothing has changed at all.

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
Ok, I re adjusted the Z height lower and this has fixed the ...

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
Overnight this has just started. I'm running MK3 with PLA, t...

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
First layer issue need advice on this please

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
You do connect underneath for hot wheels track and it's the ...

Dans le forum How do I print this? (Printing help)

il y a 3 years
Yes that's correct, the connectors are wide and generally lo...

Dans le forum How do I print this? (Printing help)

il y a 3 years
Yes the holes are massive and unfortunately that's how you c...

Dans le forum How do I print this? (Printing help)

il y a 3 years
Thanks Dan, I haven't totally found the issue yet as I'm wor...

Dans le forum How do I print this? (Printing help)

il y a 3 years
I can now see where the issue is, I was looking there myself...

Dans le forum How do I print this? (Printing help)

il y a 3 years
Ok, that's interesting it is starting at the top of the prin...

Dans le forum How do I print this? (Printing help)

il y a 3 years
3mf zip file attached Attachment removed

Dans le forum How do I print this? (Printing help)

il y a 3 years
Page 1 / 3
Partager :