Prusa3D Forum

Notifications

Clear all

Oscar

Grupa: Zarejestrowany

Dołączył: 2022/11/13

Active Member

	I'm happy to inform that it was the heater. I went ahead and... In forum Hardware, firmware and software help	2 years temu
	I’ve order the replacement. I will update after it arrives. ... In forum Hardware, firmware and software help	2 years temu
	Update: Board fuses.Ok here.Voltage on the heater at the boa... In forum Hardware, firmware and software help	2 years temu
	Correction, 1.5 ohms In forum Hardware, firmware and software help	2 years temu
	Wires were definitely touching each other, I was able to sep... In forum Hardware, firmware and software help	2 years temu
	Are you saying the two wires going in the hot end, the white... In forum Hardware, firmware and software help	2 years temu
	I have the exact same problem as described above. So far… ... In forum Hardware, firmware and software help	2 years temu

Statystyki Forum

566 Fora

63.1 K Tematy

444.1 K Posty

19 Online

68 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte