Prusa3D Forum

Notifications

Clear all

ormstont

Skupina: Registrovaný

Přidal se: 2022/09/04

Active Member

	So…followed the instructions to take the back off the extrud... In forum Assembly and first prints troubleshooting	před 3 years
	For the cal cube I generated the gcode using a fresh install... In forum Assembly and first prints troubleshooting	před 3 years
	Ok…tiny 10mm test cube looks a lot better (without doing any... In forum Assembly and first prints troubleshooting	před 3 years
	Thanks!! Will check everything over…was super careful on the... In forum Assembly and first prints troubleshooting	před 3 years
	Distorted Benchy with banding 🙁 (first print) In forum Assembly and first prints troubleshooting	před 3 years

Fórum Statistiky

585 Fóra

67.9 K Témata

476.2 K Příspěvky

13 Online

75.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed