Prusa3D Forum

Notifications

Clear all

ormstont

Group: Registered

Joined: 2022/09/04

Active Member

	So…followed the instructions to take the back off the extrud... In forum Assembly and first prints troubleshooting	2 years ago
	For the cal cube I generated the gcode using a fresh install... In forum Assembly and first prints troubleshooting	2 years ago
	Ok…tiny 10mm test cube looks a lot better (without doing any... In forum Assembly and first prints troubleshooting	2 years ago
	Thanks!! Will check everything over…was super careful on the... In forum Assembly and first prints troubleshooting	2 years ago
	Distorted Benchy with banding 🙁 (first print) In forum Assembly and first prints troubleshooting	2 years ago

Forum Statistics

566 Forums

63.2 K Topics

444.4 K Posts

21 Online

68.1 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed