Aktivita
 
Notifications
Clear all
OPK
OPK
Skupina: Registrovaný
Přidal se: 2018/06/13
Trusted Member
3
Thanks bobstro - I tried that; still can't compare to the "t...

In forum Print tips (Archive)

před 6 years
Check out Meshmixer; These are the only supports I will use...

In forum Print tips (Archive)

před 6 years
By-the-way, if you want stronger prints, use a larger nozzle...

In forum Awesome prints (Hall Of Fame)

před 6 years
The Ruby did not work for me but since I moved to a steel 0....

In forum Awesome prints (Hall Of Fame)

před 6 years
"So given the large numbers already shipped, I too am surpri...

In forum General discussion, announcements and releases

před 6 years
@sergey.s4 Those different filaments, at what "maximum volum...

In forum Awesome prints (Hall Of Fame)

před 6 years
This is really good info! I just saved myself 300 euro as Im...

In forum General discussion, announcements and releases

před 6 years
Got the same, but what worked for me: open the downloads pag...

In forum General discussion, announcements and releases

před 6 years
I was wondering about the difference in strength too. E.g. t...

In forum Awesome prints (Hall Of Fame)

před 6 years
Slow yes, but is it slooooow? E.g. normal print time: 40 min...

In forum General discussion, announcements and releases

před 6 years
😳

In forum Assembly and first prints troubleshooting

před 6 years
SlicerPE - Printer settings - Speed

In forum General discussion, announcements and releases

před 6 years
Slow! 20-30mm/s

In forum Aide concernant le matériel, le firmware ou un logiciel

před 6 years
perhaps?

In forum Assembly and first prints troubleshooting

před 6 years
MMU 2 printing times increase for supports

In forum General discussion, announcements and releases

před 6 years
+1 for the LCD display. The rattle stops when I push the par...

In forum Assembly and first prints troubleshooting

před 6 years
Thanks for your response. Luckily there is no need to use it...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 6 years
... looking at the available youtube videos: perhaps best is...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 6 years
Hmm, nobody with a normal enclosure has build it so that rol...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 6 years
Hi Gary, you are replacing the left fan with another. I cut ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 6 years
Stránka 3 / 5
Share: