Notifications
Clear all
Omikron
Omikron
Skupina: Registrovaný
Přidal se: 2016/06/16
Estimable Member
4
I've been traveling too much to be able to set up mine yet, ...

In forum Improvements (Archive)

před 8 years
Me again! Been trying to get back to tinkering with the stl ...

In forum Others (Archive)

před 8 years
Just go to an auto store and buy a sample or small bottle of...

In forum Prusa i3 kit (Archive)

před 8 years
Is anybody else seeing issue with retraction settings being ...

In forum General discussion, announcements and releases

před 8 years
It's not the easiest in the world to use (at least for me), ...

In forum Print tips (Archive)

před 8 years
Great work, Martin! I will definitely be adding this to my ...

In forum Improvements (Archive)

před 8 years
Thanks, I haven't tried ABS yet. I jumped from PLA to PETG ...

In forum Print tips (Archive)

před 8 years
Can't disagree on that. Which is why I use only my cheapest ...

In forum Others (Archive)

před 8 years
Perhaps this is a bit too obvious of a response to be what y...

In forum Print tips (Archive)

před 8 years
I think it might be useful if Prusa Research were to publish...

In forum Others (Archive)

před 8 years
I've had good experiences using torx screwdriver bits in lie...

In forum Others (Archive)

před 8 years
My printer has been idle for about a week now, because I jus...

In forum Print tips (Archive)

před 8 years
Interesting thought. I had never really considered that. I ...

In forum Print tips (Archive)

před 8 years
Delrin, the plastic that is used for the z-nut that goes on ...

In forum Prusa i3 kit (Archive)

před 8 years
Stepping on beads isn't so bad, one of those little paper ba...

In forum Print tips (Archive)

před 8 years
what do you mean with your z-axis calibration is reset? I'm...

In forum Prusa i3 kit (Archive)

před 8 years
To my knowledge such a thing does not exist but boy would it...

In forum Improvements (Archive)

před 8 years
WD-40 is quite good for flushing out contaminants and old gr...

In forum Others (Archive)

před 8 years
Thanks for the tip on the cases for the center of the spool....

In forum Print tips (Archive)

před 8 years
... before packing it in an airtight bag with a silca gel cy...

In forum Print tips (Archive)

před 8 years
Stránka 1 / 11
Share: