Deutsch
Foren
Mitglieder
OldSalty3D
Aktivität
 
Benachrichtigungen
Alles löschen
OldSalty3D
OldSalty3D
Gruppe: Registriert
Beigetreten: 2017/12/21
Trusted Member
3
Profil Aktivität
You can move the points a little to increase this to 15 mm^3...

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
[...] When I switched over to using a different slicer that ...

Im Forum Others (Archive)

 Vor 6 years
I just read your post in the "OctoPrint issues" thread. If y...

Im Forum Others (Archive)

 Vor 7 years
Thanks for everyone's help. I had completely missed the "an...

Im Forum Others (Archive)

 Vor 7 years
wow...thats weired then, didn't ecpect that. what slicer sre...

Im Forum Others (Archive)

 Vor 7 years
put a G92 E0 before the G28 W. That should solve your proble...

Im Forum Others (Archive)

 Vor 7 years
you're not using glossy or translucent filament are you? try...

Im Forum Others (Archive)

 Vor 7 years
MK3 Retracts a ton a filament right before bed leveling

Im Forum Others (Archive)

 Vor 7 years
Has anyone been getting the "MINTEMP Error" since the latest...

Im Forum Hardware, firmware and software help

 Vor 7 years
Has anyone been getting the "MINTEMP Error" since the latest...

Im Forum Hardware, firmware and software help

 Vor 7 years
I assembled my MK3 last weekend and noticed that it seemed l...

Im Forum Prusa i3 kit (Archive)

 Vor 7 years
Does it sound like a scraping noise? like the pulley is scr...

Im Forum Prusa i3 kit (Archive)

 Vor 7 years
I've been reading through this thread over the past couple o...

Im Forum General discussion, announcements and releases

 Vor 7 years
thermistors are low cost temperature sensors, they may be wi...

Im Forum Others (Archive)

 Vor 7 years
I’m also having to run all filaments 10 - 15 degrees hotter ...

Im Forum Others (Archive)

 Vor 7 years
Why wont PLA print at the same temperature as my other machi...

Im Forum Others (Archive)

 Vor 7 years
Seite 4 / 4
Teilen: