Prusa3D Forum

Notifications

Clear all

OeschMe

Groupe: Enregistré

A(ont) rejoint: 2021/11/16

Active Member

	Feature req, printables.com - List models by date they're fe... Dans le forum General discussion, announcements and releases	il y a 3 years
	I had same issue, turned out I had places bearings (on the s... Dans le forum Hardware, firmware and software help	il y a 3 years
	38min 45sec was the original. That's about the same amount o... Dans le forum Hardware, firmware and software help	il y a 4 years
	Hi! Seems, that now when I try to replicate it it's only ... Dans le forum Hardware, firmware and software help	il y a 4 years
	Yes, on display and remote connect screen. I compared printe... Dans le forum Hardware, firmware and software help	il y a 4 years
	Yes. It is connected to internet via LAN and the difference ... Dans le forum Hardware, firmware and software help	il y a 4 years
	If I for example start a 7 minute print at 14:00, the printe... Dans le forum Hardware, firmware and software help	il y a 4 years
	Estimated time (internal clock) is off by 10 minutes Dans le forum Hardware, firmware and software help	il y a 4 years

Statistiques du forum

585 Forums

68.2 K Sujets

478 K Messages

11 En-ligne

76 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé