Prusa3D Forum

Notifications

Clear all

Nirin

Grupa: Zarejestrowany

Dołączył: 2020/06/26

Active Member

	@dan-p12 If my current attempts fails, I may well give that ... In forum How do I print this? (Printing help)	4 years temu
	@dan-p12 No. The top edges are bevelled, so without cooling ... In forum How do I print this? (Printing help)	4 years temu
	I use a slow/medium print speed (around 35mm/s) and I have n... In forum How do I print this? (Printing help)	4 years temu
	Smooth PEI magnetic from the Mk3s. In forum How do I print this? (Printing help)	4 years temu
	One suggestion I've had elsewhere is to try using a raft ins... In forum How do I print this? (Printing help)	4 years temu
	Struggling to print a perfectly flat (no warping) cube in PE... In forum How do I print this? (Printing help)	4 years temu
	Slowing down printer for small objects - possible? In forum How do I print this? (Printing help)	4 years temu
	@hoydavidj Interesting. For these prints I've been using Cur... In forum How do I print this? (Printing help)	5 years temu
	@joantabb My last print was done at 0.4mm retractions, its n... In forum How do I print this? (Printing help)	5 years temu
	MK3s - PLA clogging on every print - heat creep? In forum How do I print this? (Printing help)	5 years temu

Statystyki Forum

565 Fora

64.1 K Tematy

448.9 K Posty

19 Online

70.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte