Prusa3D Forum

Notifications

Clear all

Nikomi

Groupe: Enregistré

A(ont) rejoint: 2020/11/09

Active Member

	@fernando-t-2 Yes, earlier version works different. I think ... Dans le forum General discussion, announcements and releases	il y a 4 years
	@fernando-t-2 If you have stock extruder everything is ok. S... Dans le forum General discussion, announcements and releases	il y a 4 years
	@fernando-t-2 If you have Bondtech extruder, Z calibration w... Dans le forum General discussion, announcements and releases	il y a 4 years
	@fernando-t-2 I have tried 4.3.0 rc1 first. Fan test didn't ... Dans le forum General discussion, announcements and releases	il y a 4 years
	@karl-herbert Thanks a lot! Dans le forum General discussion, announcements and releases	il y a 4 years
	Is there something like that for Mac? Dans le forum General discussion, announcements and releases	il y a 4 years
	The key to a successful 3d print is a stable printing temper... Dans le forum General discussion, announcements and releases	il y a 4 years
	There is a big reason why there are three teflon tubes on th... Dans le forum General discussion, announcements and releases	il y a 4 years

Statistiques du forum

565 Forums

63.5 K Sujets

446 K Messages

23 En-ligne

68.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé