Prusa3D Forum

Notifications

Clear all

nifl_dude

Groupe: Enregistré

A(ont) rejoint: 2020/12/30

Active Member

	To me this issue occurs even with latest firmware 6.0 Error... Dans le forum Hardware, firmware and software help	il y a 1 year
	I also tried 5.1.2, the same. A different error code was fix... Dans le forum Hardware, firmware and software help	il y a 2 years
	I did, I also contacted support, not a known issue, they sen... Dans le forum Hardware, firmware and software help	il y a 2 years
	This message occurs after I power down the printer then turn... Dans le forum Hardware, firmware and software help	il y a 2 years
	Firmware file missing in the USB drive error at boot after f... Dans le forum Hardware, firmware and software help	il y a 2 years
	I can confirm that these drivers work for windows 8.1 x64. I... Dans le forum Hardware, firmware and software help	il y a 5 years
	Thank you, that is the first layer, I will try the calibrat... Dans le forum PrusaSlicer	il y a 5 years
	Thank you for your response. Indeed ironing is not the prope... Dans le forum PrusaSlicer	il y a 5 years
	First layer as ironing? Dans le forum PrusaSlicer	il y a 5 years

Statistiques du forum

585 Forums

68 K Sujets

476.4 K Messages

11 En-ligne

75.6 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé