|
Updated to 3.1.2 here as well and got the same problems. Nev... Dans le forum Buddy3D |
il y a 2 weeks |
|
The chamber temperature would be really useful for adding an... Dans le forum Prusa Connect & PrusaLink |
il y a 3 months |
|
As I Kluber microlube is unavailable/expensive to get, I als... Dans le forum Hardware, firmware and software help |
il y a 3 months |
|
Thanks for your reply! I am currently looking to get the lub... Dans le forum Assembly and first prints troubleshooting |
il y a 3 months |
|
I got the same sound, but I am not aware if I had it before.... Dans le forum Assembly and first prints troubleshooting |
il y a 3 months |
|
Ticking sound linear rail Dans le forum Hardware, firmware and software help |
il y a 3 months |
|
Update. Apparently under filaments there is an option whethe... Dans le forum Hardware, firmware and software help |
il y a 4 months |
|
The whole chamber is being put on a lower pressure by the fa... Dans le forum Hardware, firmware and software help |
il y a 4 months |
|
Okay, then it just doesn't work on my printer for some reaso... Dans le forum Hardware, firmware and software help |
il y a 4 months |
|
I am running 6.3.4, To test I put the filtration settings on... Dans le forum Hardware, firmware and software help |
il y a 4 months |
|
It's on DIY. What I think is happening is that it only contr... Dans le forum Hardware, firmware and software help |
il y a 4 months |
|
Filtration using stock fans Dans le forum Hardware, firmware and software help |
il y a 4 months |
