Notifications
Clear all
Nicolo
Skupina: Registrovaný
Přidal se: 2020/08/11
Active Member
1
| I think my nozzle might b uneven but it doesn't seem like th... | před 5 years | |
| I see mine is very consistent and I've only seen it not happ... | před 5 years | |
| I'm recalibrating the bed and z right now because I just too... | před 5 years | |
| I'm not quite sure I have only ran first layer tests and pri... | před 5 years | |
| Y axis pause | před 5 years | |
| @jerry-s3 I think I have it almost figured out my Y-axis bel... | před 5 years | |
| Calibration errors | před 5 years | |
| I've tried both of these multiple times and I still fail to ... | před 5 years | |
| How to fix nozzle head | před 5 years | |
| How do you fix the nozzle not fitting properly because I thi... | před 5 years | |
| @neophyl Do you have any idea of what problem it could be be... | před 5 years | |
| -0.935 did better but there is still gaps and the print stil... | před 5 years | |
| z calibration/print issues | před 5 years | |
| That worked thank you! I'm a bit confused because I still ha... | před 5 years | |
| Print sliding | před 5 years |