Notifications
Clear all
Nicolo
Group: Registered
Joined: 2020/08/11
Active Member
1
| I think my nozzle might b uneven but it doesn't seem like th... | 6 years ago | |
| I see mine is very consistent and I've only seen it not happ... | 6 years ago | |
| I'm recalibrating the bed and z right now because I just too... | 6 years ago | |
| I'm not quite sure I have only ran first layer tests and pri... | 6 years ago | |
| Y axis pause | 6 years ago | |
| @jerry-s3 I think I have it almost figured out my Y-axis bel... | 6 years ago | |
| Calibration errors | 6 years ago | |
| I've tried both of these multiple times and I still fail to ... | 6 years ago | |
| How to fix nozzle head | 6 years ago | |
| How do you fix the nozzle not fitting properly because I thi... | 6 years ago | |
| @neophyl Do you have any idea of what problem it could be be... | 6 years ago | |
| -0.935 did better but there is still gaps and the print stil... | 6 years ago | |
| z calibration/print issues | 6 years ago | |
| That worked thank you! I'm a bit confused because I still ha... | 6 years ago | |
| Print sliding | 6 years ago |