Nicolas – Activité – Prusa3D Forum

Notifications

Clear all

Nicolas

Groupe: Enregistré

A(ont) rejoint: 2016/05/19

Eminent Member

	Hi Josef, I was going to ask the same question. I looked ... Dans le forum Others (Archive)	il y a 9 years
	Do you try to make your 1st layer less squished by adjusting... Dans le forum Others (Archive)	il y a 9 years
	I have already suggested to Josef Prusa it would be great to... Dans le forum Others (Archive)	il y a 9 years
	thx for the information 😉 Dans le forum Others (Archive)	il y a 9 years
	Sorry for the maybe "dumb" question, but what do you call ZH... Dans le forum Others (Archive)	il y a 9 years
	From my little experience, you really have to wait until it'... Dans le forum Others (Archive)	il y a 9 years
	For the Y axis, you can ajust the frame position by playing ... Dans le forum Others (Archive)	il y a 9 years
	Are you sure you have imported the settings correctly ? I d... Dans le forum General discussion, announcements and releases	il y a 9 years
	Yes, I have some pictures, not very good, but I can't take b... Dans le forum Others (Archive)	il y a 9 years
	Newbie's debriefing Dans le forum Others (Archive)	il y a 9 years
	No, I have never used 3.0 firmeware. I think it happened aft... Dans le forum Others (Archive)	il y a 9 years
	I'm using the 3.0.1 firmeware and I've got the same behaviou... Dans le forum Others (Archive)	il y a 9 years
	Hi, I thanks for the setting, it works very well. I've pl... Dans le forum General discussion, announcements and releases	il y a 9 years

Page 2 / 2 Précédent

Statistiques du forum

585 Forums

68.2 K Sujets

477.7 K Messages

16 En-ligne

75.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé