|
Update: I replaced the 74HC4050 level shifter chip on the bo... En el foro Hardware, firmware and software help |
hace 1 year |
|
Unfortunately software (incl. firmware) updates are more oft... En el foro Hardware, firmware and software help |
hace 1 year |
|
Already tried swapping the ribbon cables around, and didn't ... En el foro Hardware, firmware and software help |
hace 1 year |
|
I've just upgraded the firmware of the printer to version 3.... En el foro Hardware, firmware and software help |
hace 1 year |
|
With no other suggestions, I've gone ahead and replaced the ... En el foro Hardware, firmware and software help |
hace 1 year |
|
I know, my question was rather, how does changing the firmwa... En el foro Hardware, firmware and software help |
hace 1 year |
|
Printing via USB works fine though, so wouldn't that suggest... En el foro Hardware, firmware and software help |
hace 1 year |
|
That's something I hadn't thought about, I'll have a look at... En el foro Hardware, firmware and software help |
hace 1 year |
|
I followed your advice to clean the pins internally with IPA... En el foro Hardware, firmware and software help |
hace 1 year |
|
The pins look properly soldered on the outside, but had to l... En el foro Hardware, firmware and software help |
hace 1 year |
|
@diem I tried the masking tape suggestion but as expected, i... En el foro Hardware, firmware and software help |
hace 1 year |
|
I've tried multiple cards, including the original one, alway... En el foro Hardware, firmware and software help |
hace 1 year |
|
Thanks for the reply @neophyl. I conducted a thorough visual... En el foro Hardware, firmware and software help |
hace 1 year |
|
Unable to read SD cards En el foro Hardware, firmware and software help |
hace 2 years |
|
@tim-m30 Point taken, Tim. However when I bought the Prusa M... En el foro Assembly and first prints troubleshooting |
hace 5 years |
|
Update: it appears the collet that holds the PTFE tube in pl... En el foro Assembly and first prints troubleshooting |
hace 5 years |
|
That's possible, because I had to apply a lot of force to th... En el foro Assembly and first prints troubleshooting |
hace 5 years |
|
Tim, I just received the piece of PTFE tube from Ebay, and s... En el foro Assembly and first prints troubleshooting |
hace 5 years |
|
Tim, are my survey answers: Printer: MK3S Material being pri... En el foro Assembly and first prints troubleshooting |
hace 5 years |
|
The area above the blob is still 1.75 mm in diameter as meas... En el foro Assembly and first prints troubleshooting |
hace 5 years |
