|
So far I've only used the (now deformed) original PTFE tube ... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
|
I wasn't aware of the existence of PTFE tubes with different... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
|
As far as I could tell, both fans were running normally, so ... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
|
Yes I do have the black clip installed to keep the PTFE tube... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
|
I don't think the PTFE itself ever melted, the melting point... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
|
Tim, in the filament picture, the side with the blob (lower ... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
|
Yes the PTFE tube got deformed because the extruder stepper ... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
|
Tim, here is a picture of the lower piece of filament that I... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
|
Thanks for the info everyone, as a newbie in 3D printer trou... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
|
Hi bobstro, thanks for sharing your thoughts! I don't think ... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
|
Thanks for the input, bobstro. I've checked the channel and ... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
|
Hi all, I have the same problem, filament keeps jamming just... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
|
Extruder wheel and PTFE tube appear to be lined up correctly... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
|
New Prusa MK3S, extruder jammed Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |
