Notifications
Clear all
Nick
Nick
Skupina: Registrovaný
Přidal se: 2016/10/18
Trusted Member
3
Z calibration makes a big difference. Also bed leveling can...

In forum Others (Archive)

před 8 years
Mesh Bed Levelling and G80 in Gcode

In forum Prusa i3 kit (Archive)

před 8 years
I also find that after printing with ABS I clean the bed wit...

In forum Others (Archive)

před 8 years
I have just posted a similar error albeit under a different ...

In forum Print tips (Archive)

před 8 years
ok, complete strip down and rebuild for the heated bed and b...

In forum Others (Archive)

před 8 years
Banding issue in layers

In forum Others (Archive)

před 8 years
How much more stable are we talking for this. I have my prin...

In forum Hardware, firmware and software help

před 8 years
I would love to see an overall print speed reduction the sam...

In forum Software (Archive)

před 8 years
I got similar results when I had the hotend temp too high, t...

In forum Others (Archive)

před 8 years
I personally would like to have seen more about linear beari...

In forum Hardware, firmware and software help

před 8 years
Cancelling on Heat Up

In forum Improvements (Archive)

před 8 years
The only thing I can think is that the 100mm gap between the...

In forum Assembly and first prints troubleshooting

před 8 years
It searches back and forth on that calibration, I would star...

In forum Assembly and first prints troubleshooting

před 8 years
I have printed all heights and sizes and pla and abs in sile...

In forum Others (Archive)

před 8 years
Funny question Peter, but why is there no centre option for ...

In forum Others (Archive)

před 8 years
You have made sure that the bed is properly clean after the ...

In forum Assembly and first prints troubleshooting

před 8 years
I start at 55 for first layer, then have it increase to 63-6...

In forum Print tips (Archive)

před 8 years
Did you have customised settings before and did you re-impor...

In forum Others (Archive)

před 8 years
your bed shouldn't be any higher than 65, I think 63 is the ...

In forum Print tips (Archive)

před 8 years
Bed Temperature

In forum Hardware, firmware and software help

před 8 years
Stránka 2 / 4
Share: