Avisos
Vaciar todo
ngen33r
Grupo: Registrado
Registrado: 2023/03/17
Active Member
1
|
That indeed was the issue. I made the mistake of assuming th... En el foro PrusaSlicer |
hace 2 years | |
|
Firmware is 2.0.7.2. The control board is the OEM Rumba that... En el foro PrusaSlicer |
hace 2 years | |
|
Attached is the project file: cube S3D Start GCODE G28 ; hom... En el foro PrusaSlicer |
hace 2 years | |
|
Custom profile will not print correctly. Severly under extru... En el foro PrusaSlicer |
hace 2 years | |
| Let me throw my worthless $0.02 in there on this beat to dea... | hace 3 years |