Čeština
Fóra
Uživatelé
Nerys
Aktivita
 
Notifications
Clear all
Nerys
Nerys
Skupina: Registrovaný
Přidal se: 2023/02/20
Active Member
1
Profile Aktivita
Where in the world is set target temperature?

In forum PrusaSlicer

 před 2 years
this is a standard long existing feature in simplify 3D I us...

In forum PrusaSlicer

 před 2 years
Multi Process? how do I do per layer multi process?

In forum PrusaSlicer

 před 2 years
I need to define the "start point" of the print but can't fi...

In forum PrusaSlicer

 před 3 years
ohhhhhhh I think I found the settings !!! not only is it cor...

In forum PrusaSlicer

 před 3 years
if you can can you send me your profile settings? mine fails...

In forum PrusaSlicer

 před 3 years
I sliced in 2.6r4 and the gaps are STILL present!! so there ...

In forum PrusaSlicer

 před 3 years
Interesting. I am using latest release 2.5 I will go get 2.6...

In forum PrusaSlicer

 před 3 years
ok its not microgaps at all. there are none in the model. I ...

In forum PrusaSlicer

 před 3 years
SO there must be some micro gaps I can not see in the model ...

In forum PrusaSlicer

 před 3 years
I am a bit of a novice when it comes to modeling. so bear wi...

In forum PrusaSlicer

 před 3 years
and yes min gap must be zero or it makes spaghetti 🙂

In forum PrusaSlicer

 před 3 years
Here is S3d in blue and Prusa in Orange

In forum PrusaSlicer

 před 3 years
that viewing angle does not show the issue. the issue is on ...

In forum PrusaSlicer

 před 3 years
OK in the modelling program that "error" does not appear to ...

In forum PrusaSlicer

 před 3 years
Your understanding is incorrect but it's also understandable...

In forum PrusaSlicer

 před 3 years
Problem with slicing complex vase mode models

In forum PrusaSlicer

 před 3 years
Share: