|
Did you zip it up ? As no file is attached. It has to be z... In forum Hardware, firmware and software help |
5 months ago |
|
This issue has been reported multiple times on the PS github... In forum Hardware, firmware and software help |
5 months ago |
|
Ive just run the wizard again and Prusa seem to have standar... In forum PrusaSlicer |
5 months ago |
|
The problem with blockers if you are using the modifiers tha... In forum PrusaSlicer |
5 months ago |
|
If its the amount of current drawn that is interfering with ... In forum Hardware, firmware and software help |
5 months ago |
|
From the multiple issues on the PS github over the years man... In forum PrusaSlicer |
5 months ago |
|
There are no settings to control that. The changes are due ... In forum PrusaSlicer |
5 months ago |
|
Yes you are impatient 🙂 2.9.3 is released and available on... In forum PrusaSlicer |
6 months ago |
|
Dont think so but you could compare the prusa slicer output ... In forum PrusaSlicer |
6 months ago |
|
I think its because you have a different extruder defined fo... In forum PrusaSlicer |
6 months ago |
|
You will come to the realisation that prusa quite often are ... In forum General discussion, announcements and releases |
6 months ago |
|
Thanks for the info, that would be the Parameter I mentioned... In forum General discussion, announcements and releases |
6 months ago |
|
Now you have them back take the opportunity to perform a Con... In forum PrusaSlicer |
6 months ago |
|
All feature requests need to be made at the appropriate Prus... In forum General discussion, announcements and releases |
6 months ago |
|
It could be a divide by zero or one that the result is cast ... In forum General discussion, announcements and releases |
6 months ago |
|
All non prusa profiles are supplied to them by the community... In forum PrusaSlicer |
6 months ago |
|
It is absolutely detrimental to have multiple lines of extru... In forum General discussion, announcements and releases |
6 months ago |
|
Please don't do what Tim suggests. Objects are sliced indiv... In forum General discussion, announcements and releases |
6 months ago |
|
There are multiple threads here (and also on the prusa slice... In forum PrusaSlicer |
6 months ago |
