Notifications
Clear all
neil.g4
Groupe: Enregistré
A(ont) rejoint: 2018/05/03
New Member
|
extruder gear on motor stops turning MK3 Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
hi,
Thanks for the suggestions. I did a cold pull about 4 t... Dans le forum Hardware, firmware and software help |
il y a 7 years | |
|
Thank you Tim,
I will try to clean the PTFE tube. I watched... Dans le forum Hardware, firmware and software help |
il y a 7 years | |
|
Filament is very thin Dans le forum Hardware, firmware and software help |
il y a 7 years |