Notifications
Clear all
neil.g4
Group: Registered
Joined: 2018/05/03
New Member
|
extruder gear on motor stops turning MK3 In forum Hardware, firmware and software help |
5 years ago | |
|
hi,
Thanks for the suggestions. I did a cold pull about 4 t... In forum Hardware, firmware and software help |
6 years ago | |
|
Thank you Tim,
I will try to clean the PTFE tube. I watched... In forum Hardware, firmware and software help |
6 years ago | |
|
Filament is very thin In forum Hardware, firmware and software help |
6 years ago |