Prusa3D Forum

Notifications

Clear all

nedge2k

Skupina: Registrovaný

Přidal se: 2017/05/21

New Member

	PID and temp calibration, yes. No difference. As for Joan, I... In forum Hardware, firmware and software help	před 5 years
	The fact that the reading has suddenly drifted out of spec m... In forum Hardware, firmware and software help	před 5 years
	Think i've figured this out. Used a thermocouple connected t... In forum Hardware, firmware and software help	před 5 years
	Extruder badly skipping for no obvious reason In forum Hardware, firmware and software help	před 5 years

Fórum Statistiky

565 Fóra

63.8 K Témata

447.5 K Příspěvky

23 Online

69.5 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed