Notifications
Clear all
nathan118
Skupina: Registrovaný
Přidal se: 2019/03/01
Active Member
1
|
Unload Filament Command Only Gives 30 Seconds to Comply In forum Hardware, firmware and software help |
před 10 months | |
| @bobstro All I'm asking is that they release the stls, and d... | před 4 years | |
| Yah, it's unfortunate. This should have been an item on thei... | před 4 years | |
| Chat said they could email it to me...but nothing yet. 😔 | před 4 years | |
| Mk3s+ Stls needed... | před 4 years | |
| Got my Mk3s+ today, but I spun a hex nut in the extruder bod... | před 4 years |