Prusa3D Forum

Notifications

Clear all

Nanoplane

Skupina: Registrovaný

Přidal se: 2021/02/12

Active Member

	cover 2.3mfLatest version with the large bridge at 4.75mm In forum PrusaSlicer	před 8 months
	Ok, set it up as you advised... and I can't seem to get rid ... In forum PrusaSlicer	před 8 months
	So, depending on what you do, you can get weird results ... ... In forum PrusaSlicer	před 8 months
	The lack of a bottom layer was intentional.. wanted to get a... In forum PrusaSlicer	před 8 months
	cover-PTest.3mfIn this test, it doesn't seem to matter what ... In forum PrusaSlicer	před 8 months
	PrusaSlicer 2.9 seems to ignore bridge direction. In forum PrusaSlicer	před 8 months
	OOps, bad URL... here's the correct one: SuperSlicerMx In forum PrusaSlicer	před 5 years
	@sjones So, I'm working on this.. it's a work in progress ri... In forum PrusaSlicer	před 5 years
	Here's the first update.. this is even usable since the new ... In forum PrusaSlicer	před 5 years
	Support for mixing hot-ends.. In forum PrusaSlicer	před 5 years
	Purging Volumes interface bug. In forum PrusaSlicer	před 5 years
	Purging Volumes interface seems to have a bug (at least on t... In forum PrusaSlicer	před 5 years
	I have the same question... In forum PrusaSlicer	před 5 years

Fórum Statistiky

585 Fóra

68.2 K Témata

477.5 K Příspěvky

15 Online

75.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed