|
Ok... so downgrading from 6.4 to 6.2.6 fixed the issue... Pr... In forum Hardware, firmware and software help |
1 week ago |
|
I have 6.4 installed. I haven't had issues with anything els... In forum Hardware, firmware and software help |
1 week ago |
|
Yes, it's an XL5 .... In forum Hardware, firmware and software help |
1 week ago |
|
Can't get XL to nozzle clean or bed level with PP filament o... In forum Hardware, firmware and software help |
1 week ago |
|
cover 2.3mfLatest version with the large bridge at 4.75mm In forum PrusaSlicer |
1 year ago |
|
Ok, set it up as you advised... and I can't seem to get rid ... In forum PrusaSlicer |
1 year ago |
|
So, depending on what you do, you can get weird results ... ... In forum PrusaSlicer |
1 year ago |
|
The lack of a bottom layer was intentional.. wanted to get a... In forum PrusaSlicer |
1 year ago |
|
cover-PTest.3mfIn this test, it doesn't seem to matter what ... In forum PrusaSlicer |
1 year ago |
|
PrusaSlicer 2.9 seems to ignore bridge direction. In forum PrusaSlicer |
1 year ago |
|
OOps, bad URL... here's the correct one: SuperSlicerMx In forum PrusaSlicer |
5 years ago |
|
@sjones So, I'm working on this.. it's a work in progress ri... In forum PrusaSlicer |
5 years ago |
|
Here's the first update.. this is even usable since the new ... In forum PrusaSlicer |
5 years ago |
|
Support for mixing hot-ends.. In forum PrusaSlicer |
5 years ago |
|
Purging Volumes interface bug. In forum PrusaSlicer |
5 years ago |
|
Purging Volumes interface seems to have a bug (at least on t... In forum PrusaSlicer |
5 years ago |
|
I have the same question... In forum PrusaSlicer |
5 years ago |
